RF & Wireless Development

Wireless is where otherwise well-designed products fail. RF performance depends on antenna placement, stackup, ground plane geometry, enclosure materials, and everything else on the board. If the link budget is not part of the design from day one, you find out at the range test, after the enclosure is tooled.

We have shipped RF through a sealed machined-aluminum remote enclosure, reverse-engineered an existing control protocol to keep backward compatibility, and held sleep current in the microamps on battery products. We choose the protocol from your range, power, latency, and regulatory numbers.

We also run FCC pre-compliance before you tool anything, because an emissions failure after tooling is a very expensive way to learn about a slot antenna you did not know you had.